1991 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Brake Fluid Level Light

Remove cap and brake level switch from brake fluid reservoir. Clean any foreign material from terminal connector. Using an ohmmeter, check brake level switch continuity. With brake fluid switch float raised, continuity should not exist. With brake fluid switch float lowered, continuity should exist.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.