1991 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Power Brake Unit Output Rod

  1. Attach a hand-held vacuum pump to power brake unit supply port. Apply 20 in. Hg vacuum to power brake unit. Measure length of output rod extending from power brake unit housing. See Fig 1 .
  2. Output rod length should be .40-.41" (10.3-10.5 mm). Adjust output rod length, if necessary. See Fig 1 . If adjustment cannot be obtained, replace power brake unit.
Fig 1: Measuring Length of Output Rod Extending from Power Brake Unit Housing. Courtesy of Nissan Motor Co., U.S.A.
G91I02376
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.