1990 Nissan-Datsun Van XE, StandardFACTORY OEM SERVICE PROCEDURE

Engine Stall: Accelerating

  1. Connect inductive timing light to spark plug wire and check for weakness in flash.
  2. Ensure spark plug wires are within allowable resistance values.
  3. Check for spark using spark tester.
  4. Ensure engine has adequate compression.
  5. Enter self-diagnostic Mode II and monitor fuel metering system operation.
  6. Disconnect exhaust gas sensor and monitor change in driveability. If it improves, replace sensor. If not, go to 5.
  7. For Crank Angle Sensor & Airflow Meter: Enter self-diagnostic Mode III and retrieve codes. If vehicle will not start, crank engine before entering self-diagnostic Mode III.
  8. For Crank Angle Sensor & Airflow Meter: Enter self-diagnostic Mode V and monitor real-time diagnostic setting of fault codes. Perform appropriate code chart in TESTS W/CODES article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.