1990 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Fraction Decimal
2WD-Except Coupe
Camber (Degrees) -59/64 - 37/64 -.83 - .58
Caster (Degrees) 43/64 - 21/64 .67 - 2.25
Toe-In (Degrees) -1/32 - 1/16 -.06 - .13
Toe-In (Inches) -1/64 - 1/16 -.03 - .13
Toe-Out on Turns (Degrees)
Inner 21 37/64 21.58
Outer 20 20.00
Steering Axis Inclination (SAI) (Degrees) 13 1/4 - 14 3/4 13.25 - 14.75
2WD-Coupe
Camber (Degrees) -1 - 27/64 -1 - .42
Caster (Degrees) 59/64 - 2 27/64 .92 - 2.42
Toe-In (Degrees) -1/32 - 11/64 -.06 - .17
Toe-In (Inches) 9/32 - 1/2 .28 - .50
Toe-Out on Turns (Degrees)
Inner 21 37/64 21.58
Outer 20 20.00
Steering Axis Inclination (SAI) (Degrees) 13 37/64 - 15 13.58 - 15.00
4WD-Wagon
Camber (Degrees) -53/64 - 43/64 -.83 - .67
Caster (Degrees) 59/64 - 2 27/64 .92 - 2.42
Toe-In (Degrees) -1/32 - 11/64 -.06 - .17
Toe-In (Inches) -1/64 - 1/16 -.06 - .13
Toe-Out on Turns (Degrees)
Inner 22 3/32 22.19
Outer 20 20.00
Steering Axis Inclination (SAI) (Degrees) 12 53/64 - 14 13/64 12.83 - 14.33
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.