1987 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE

Toe-In Alignment (Pickup)

Adjust toe-in by varying the lenght of the steering tie-rods. Adjust toe-in by turning the left and right tie-rod tubes an equal amount. Make sure the tie-rods are screwed into the tie-rod tube more than 1.38" (35 mm).

Once adjusted, make sure that the tie-rods are the same lenght. See Fig 1 .

Fig 1: Toe In Alignment Procedure (Pickup)
G201335
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.