1987 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE

Alignment Procedures: SENTRA

NOTE: On Sentra, caster and kingpin inclination are preset at factory and cannot be adjusted.

If camber is not within specification, adjust by turning the adjusting pin see Fig 1 .

  1. Remove the adjusting pin. Adjusting pin is factory installed with the flat portion facing down.
  2. Install adjusting pin with the flat portion facing up.
  3. Turn the adjusting pin to adjust, Camber changes about 15' with each graduation of the adjusting pin. See Fig 2 .
  4. Tighten to the specified torque.
Fig 1: Adjusting Pin Location (Sentra)
G50H07316
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.