Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1975 Nissan-Datsun 280Z Automatic TransFACTORY OEM SERVICE PROCEDURE
Labor Times
- Accessories and Equipment
- Brakes
- Drivelines and Axles
- Engine Mechanical
- Suspension
- Electrical
- Engine Performance
- Fuel Delivery System
- Air Cleaner Element
- Air Flow Meter
- Air Temp Sensor
- Cold Start Valve
- Coolant Temperature Sensor
- Dropping Resistor
- Electronic Control Relay
- Electronic Control Unit
- Fuel Injection System
- Fuel Injector
- Fuel Pressure Regulator
- Induction Manifold
- Intake Manifold Gasket
- Oxygen Sensor
- Thermal Time Switch
- Throttle Chamber
- Throttle Position Sensor
- Ignition Systems
- Distributor Assembly
- Distributor Cap
- Distributor Vacuum Control
- Electronic Ignition Control Unit
- Electronic Ignition Igniter
- Electronic Ignition Pick-Up
- Electronic Ignition RELUCTOR
- Engine Compression
- Engine Cylinder Leakage
- Engine Performance
- Ignition Coil
- Ignition Timing
- Power Transistor
- Spark Plug Wire Set
- Spark Plugs
- Tune-Up
- Fuel Delivery System
- Heating, Ventilation & A/C (HVAC)
- Steering
- Transmission
- Automatic Trans
- Downshift Solenoid
- Extension Housing
- Extension Housing Seal
- Governor Assembly
- KICKDOWN Switch
- Main Control Valve Body
- Manual & Throttle Linkage
- Manual Shift Linkage
- Neutral Safety Switch
- Parking Pawl
- Speedometer Driven Gear
- Throttle Linkage
- Transmission
- Transmission Assembly
- Transmission Oil Cooler Pipes
- Transmission Oil Filler Tube Seal
- Transmission Oil Pan Gasket &/Or Filter
- Vacuum Modulator
- Clutch Manual and Hydraulic
- Manual Trans
- Automatic Trans
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.