2024 Mitsubishi Eclipse Cross LEFACTORY OEM SERVICE PROCEDURE

Removal And Installation: Notes

CAUTION: When the knock sensor is replaced, initialize the learned value using scan tool (M.U.T.-IIISE) (Refer to Precautions before Service, INITIALIZATION PROCEDURE FOR LEARNING VALUE IN DI AND MPI ENGINE ).

Pre-removal and Post-installation Operation 

Fig 1: Removing/Installing Knock Sensor Components Location With Torque Specification
G16565942Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Removal
  1. Knock sensor connector
>>A<<  2. Knock sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.