Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Mitsubishi Eclipse Cross LEFACTORY OEM SERVICE PROCEDURE
Removal And Installation: Notes
CAUTION:
- When removing or installing the crankshaft position sensor, be careful not to apply impact to the sensor.
- Do not reuse the crankshaft position sensor that has been dropped.
Pre-removal and Post-installation Operation
- Drive Belt Removal and Installation (Refer to CRANKSHAFT PULLEY ).
| Removal steps | |
|---|---|
| <<A>> | • A/C compressor and clutch assembly (Refer to COMPRESSOR ASSEMBLY ) |
| 1. Crankshaft position sensor connector | |
| 2. Crankshaft position sensor | |
| 3. O-ring | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
