2020 Mitsubishi Mirage G4 LEFACTORY OEM SERVICE PROCEDURE

Example Of Abnormal Waveforms

NOTE:
  1. The size of the waveform patterns differs largely, depending on the adjustment of the variable knob on the oscilloscope.
  2. Identification of abnormal waveforms is easier when there is a large output current (regulator is not operating). (Waveforms can be observed when the headlights are illuminated).
  3. Check the conditions of the generator malfunction light (illuminated/not illuminated). Also, check the charging system totally.
Abnormal waveform Problem cause
Example 1
G06248639Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Open diode
Example 2
G06248640Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Short in diode
Example 3
G06248641Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Broken wire in stator coil
Example 4
G06248642Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Short in stator coil
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.