Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Mitsubishi Eclipse Cross LEFACTORY OEM SERVICE PROCEDURE
Engine Overhaul: Sealants: Notes
| Application points | Specified sealant |
|---|---|
| Drive plate bolt | Three bond 1324 or equivalent |
| Engine coolant temperature sensor | LOCTITE 262, Three bond 1324N |
| Engine oil pressure switch | Three bond 1141J, Three bond 1215, Three bond 1212D |
| Oil seal case | Three bond 1227D, Three bond 1217G (Mitsubishi Motors Genuine Part No. 1000A923), LOCTITE 5900, LOCTITE 5970 |
| Oil pan | |
| Cylinder head gasket (matching area of the cylinder block, the cylinder head gasket and the cylinder head) | Three bond 1217G (Mitsubishi Motors Genuine Part No. 1000A923), LOCTITE 5900, LOCTITE 5970 |
| Timing chain case cover A, Timing chain case cover B | |
| Timing chain case (matching area of the cylinder block, the cylinder head gasket and the cylinder head) | |
| Timing chain case (Area of the water pump) | Three bond 1227D, Three bond 1207F (Mitsubishi Motors Genuine Part No. 1000A992) |
| Cylinder head cover (matching area of the cylinder head and timing chain case) | Three bond 1217G (Mitsubishi Motors Genuine Part NO. 1000A923), Three bond 1217M, LOCTITE 5900 |
| Rear camshaft bearing cap | Three bond 1217G (Mitsubishi Motors Genuine Part NO. 1000A923), LOCTITE 5900 |
| Fuel pump support | Three bond 1217G (Mitsubishi Motors Genuine Part NO. 1000A923), LOCTITE 5900, LOCTITE 5970 |
NOTE:
The number in brackets shows the genuine part number.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
