Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Mitsubishi Outlander ESFACTORY OEM SERVICE PROCEDURE
Electronically Controlled AWD DTCS
ELECTRONICALLY CONTROLLED AWD DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| C100A | FL wheel speed sensor circuit |
| C1011 | FL wheel speed sensor signal |
| C1014 | FL wheel speed sensor performance |
| C1015 | FR wheel speed sensor circuit |
| C101C | FR wheel speed sensor signal |
| C101F | FR wheel speed sensor performance |
| C1020 | RL wheel speed sensor circuit |
| C1027 | RL wheel speed sensor signal |
| C102A | RL wheel speed sensor performance |
| C102B | RR wheel speed sensor circuit |
| C1032 | RR wheel speed sensor signal |
| C1035 | RR wheel speed sensor performance |
| C1078 | Tire revolutions range |
| C1219 | Steering wheel sensor signal |
| C121A | Steering wheel sensor initialization |
| C123C | Sensor cluster malfunction |
| C1242 | Straight G sensor signal |
| C1610 | Electronic controlled coupling solenoid power supply relay fails |
| C1613 | Drive mode selector stuck |
| C1614 | Parking brake switch stuck ON |
| C1616 | Cranking signal stuck |
| C1621 | Electronic controlled coupling solenoid (center) protection |
| C1624 | AWD ECU internal |
| C1626 | Electronic controlled coupling solenoid voltage fails |
| C1628 | Electronic controlled coupling solenoid current fails |
| C1629 | ASC timeout |
| C1630 | Steering wheel sensor timeout |
| C1631 | ETACS timeout |
| C1632 | Engine timeout |
| C1633 | Transmission timeout |
| C1707 | Implausible coding data |
| C2100 | Power supply low voltage |
| C2101 | Power supply high voltage |
| C2205 | Steering wheel sensor internal error |
| U0100 | Engine CAN timeout |
| U0101 | Transmission CAN timeout |
| U0121 | ABS/ASC CAN timeout |
| U0126 | Steering wheel sensor CAN timeout |
| U0141 | ETACS CAN timeout |
| U0401 | Engine CAN message |
| U0428 | Steering wheel sensor CAN message |
| U0431 | ETACS CAN message |
| U1073 | Bus-off |
| U1195 | Coding not completed |
| U119A | Chassis No. mismatch |
| U1425 | Transmission CAN message |
| U1426 | ASC CAN Message |
| U1427 | Implausible wheel speed data |
| U1428 | Sensor Cluster CAN message |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.