2016 Mitsubishi Outlander ESFACTORY OEM SERVICE PROCEDURE

Removal And Installation: Notes

Pre-removal and Post-installation Operation 
  • Front deck garnish removal and installation (Refer to WINDSHIELD WIPER .)
  • Roof drip molding removal and installation (Refer to REMOVAL AND INSTALLATION .)
  • Front pillar trim removal and installation (Refer to INTERIOR TRIM .)
  • Inside rear view mirror assembly removal and installation (Refer to INSIDE REAR VIEW MIRROR .)
  • Lighting control sensor removal and installation < Vehicles with lighting control sensor > (Refer to LIGHTING CONTROL SENSOR .)
  • LDW-ECU bracket removal and installation < Vehicles with LDW > (Refer to LDW-ECU .)
Fig 1: Removing/Installing Windshield Components With Torque Specification (1 Of 2)
G10224639Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.