2014 Mitsubishi RVR ESFACTORY OEM SERVICE PROCEDURE

Vehicles For MEXICO

Fig 1: Identifying Vehicle General Data And Specifications (For Mexico)
G07045822
Item GA2W
XTMHLFCS XTXHLFCS
Vehicle dimension mm (in) Front track 1 1,525 (60.0) 1,525 (60.0)
Overall width 2 1,770 (69.7) 1,770 (69.7)
Front overhang 3 870 (34.3) 870 (34.3)
Wheel base 4 2,670 (105.1) 2,670 (105.1)
Rear overhang 5 755 (29.7) 755 (29.7)
Overall length 6 4,295 (169.1) 4,295 (169.1)
Ground clearance (unladen) 7 215 (8.5) 215 (8.5)
Overall height (unladen) Without roof rail 8 1,630 (64.2) 1,630 (64.2)
With roof rail 1,640 (64.6) 1,640 (64.6)
Rear track 9 1,525 (60.0) 1,525 (60.0)
Vehicle weight kg (lb) Kerb weight Without optional parts 1,405 (3,098) 1,420 (3,131)
With optional parts 1,427 (3,146) 1,474 (3,250)
Max. gross vehicle weight 1,970 (4,343) 1,970 (4,343)
Max. axle weight rating-front 1,030 (2,271) 1,030 (2,271)
Max. axle weight rating-rear 1,000 (2,205) 1,000 (2,205)
Seating capacity 5 5
Engine Model code 4B11 4B11
Type DOHC MIVEC DOHC MIVEC
Piston displacement cm3 (cu in) 1,998 (121.9) 1,998 (121.9)
Maximum output kW/r/min (HP/r/min) 110/6,000 (148/6,000) 110/6,000 (148/6,000)
Maximum torque N.m/r/min (ft-lb/r/min) 197/4,200 (145/4,200) 197/4,200 (145/4,200)
Fuel system Fuel supply system MFI MFI
Transmission Model code F1CJA F1CJA
Type FWD, INVECS-III CVT with sport mode FWD, INVECS-III CVT with sport mode
Minimum turning radius m (ft) Body 5.63 (18.5) 5.63 (18.5)
Wheel 5.3 (17.4) 5.3 (17.4)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.