Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Mitsubishi Lancer Evolution GSRFACTORY OEM SERVICE PROCEDURE
Crankcase Ventilation System Check
- Remove the ventilation hose from the positive crankcase ventilation (PCV) valve.
- Remove the PCV valve from the rocker cover.
- Reinstall the PCV valve at the ventilation hose.
- Start the engine and run at idle.
- Place a finger at the opening of the PCV valve and check that vacuum of the intake manifold is felt.NOTE: At this moment, the plunger in the PCV valve moves back and forth.
- If vacuum is not felt, clean the PCV valve or replace it.
- Apply a small amount of new engine oil to the O-ring on the PCV valve, and tighten to the specified torque.
Standard value: 2.5 Β± 0.4 N.m (22 Β± 3 in-lb)Β
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
