2013 Mitsubishi Lancer Evolution MRFACTORY OEM SERVICE PROCEDURE

Body Dimensions And Measurement Methods

  • Type A (projected dimensions) is the dimension when a measurement location is projected onto the plane.
    NOTE: The height indicates a distance from the assumed standard line established 100 mm (3.9in) below the lowest measurement point.
    G11480843Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  • Type B (actual-measurement dimensions) is the actual distance between the measurement points. Measure using a tracking gauge or a measuring tape, etc.
    NOTE:
    • Make the lengths of the tracking gauge probes the same (A=A').
    • Do not bend or twist the measuring tape.
    G11493080Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  • Insert the tracking gauge probes securely into the measurement holes.
  • When the standard dimensions in the illustration are enclosed by rectangle, this indicates that the symmetrical left and right positions have the same dimensions.
    G11480845Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  • When using a notch for dimension measurement, set the measuring point at the center of the notch.
  • The body center points are shown for the purpose of checking the position of the left and right symmetry location.
    G11478670Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.