Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Mitsubishi Lancer DEFACTORY OEM SERVICE PROCEDURE
Keyless Entry Function
WARNING: This page is about a different variant/trim than selected.
TRANSMITTER
- The transmitter button operation allows the system to operate as follows:
Transmitter Operation
| Function | Transmitter operation | System operation | |
|---|---|---|---|
| Standard function (lock/unlock/trunk lid open) | Press the lock button once. | All doors are locked. NOTE: If the retracting function of the electric folding mirrors is added using a customization function, it can be retracted in synchronization with a lock operation. | |
| Press the unlock button once. | All doors are unlocked. NOTE: If the opening function of the electrical folding mirrors is added as an adjustment function, it can be opened in synchronization with an unlock operation. | ||
| Open the trunk lid | Press the trunk lid button twice (press the button once, and press it again within 5 seconds). | ||
| Panic alarm system | Panic button | Press once (press and hold for 1 second). | Starts the panic alarm (headlights flash and horn honks for three minutes) |
| Lock button, unlock button or panic button | Press again | Stops the panic alarm in progress | |
| Power door locks with selective unlocking | Press the unlock button once to unlock the driver's door, and within 2 seconds, press the unlock button again to unlock the front passenger's door, rear doors. | Power door locks with selective unlocking. NOTE: Using a customization function, the power door locks with selective unlocking can be enabled or disabled. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
