Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mitsubishi i-MiEV ESFACTORY OEM SERVICE PROCEDURE
A/C Control Unit DTCS
A/C CONTROL UNIT DIAGNOSTIC TROUBLE CODE LIST
| DTC No. | Description |
|---|---|
| B1081 | Control panel comm.error |
| B1083 | EEPROM fail |
| B1101 | ELC. compressor (Eternity) |
| B1102 | ELC. compressor (Current) |
| B1103 | ELC. compressor (Power) |
| B1104 | ELC. compressor (Heat) |
| B1105 | ELC. compressor (Communication) (2012) |
| B1105 | ELC. compressor (Communication) (2014) |
| B1106 | ELC. compressor input VOLT. (low) |
| B1107 | ELC.compressor input VOLT. (high) |
| B1108 | Electric water heater fail 1 (2012) |
| 8 B1108 | Electric water heater fail 1 (2014) |
| B1109 | Electric water heater fail 2 (2012) |
| B1109: | Electric water heater fail 2 (2014) |
| B1110 | Electric water heater fail 3 (2012) |
| B1110 | Electric water heater fail 3 (2014) |
| B1111 | ELC.water heater inlet SNS.low |
| B1112 | ELC.water heater inlet SNS.high |
| B1113 | ELC.water heater outlet SNS.low |
| B1114 | ELC.water heater outlet SNS.high |
| B1115 | Electric water pump malfunction (2012) |
| B1115 | Electric water pump malfunction (2014) |
| B1116 | Electric water pump harness (2012) |
| B1116 | Electric water pump harness (2014) |
| B1117 | ELC.compressor (Control) |
| B1118 | ELC.compressor (Temp.Sensor) |
| B1121 | In/out select damper circuit HI |
| B1122 | In/out select damper circuit LO |
| B1123 | In/out select damper malfunction |
| U1073 | Bus-off |
| U1100 | EV-ECU CAN timeout |
| U1102 | ASC/TCL/ABS timeout/Not equipped |
| U1108 | Meter CAN timeout/Not equipped |
| U1109 | ETACS CAN timeout/Not equipped |
| U111C | BMU CAN timeout |
| U1190 | No receive fault detect signal |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
