Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2012RVR ESREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SUPPLYON-VEHICLE SERVICEFUEL PUMP MODULE REPLACEMENT
2012 Mitsubishi RVR ES
Fuel Pump Module Replacement
2012 Mitsubishi RVR ESSECTION Fuel Pump Module Replacement
- Remove the rear seat cushion assembly (Refer to REAR SEAT ASSEMBLY ) and turn up the floor carpet.
- Remove the floor inspection lid (LH).
- Disconnect the fuel pump module connector and fuel tank differential pressure sensor connector.
- Release the fuel pressure in the fuel line (Refer to REDUCE PRESSURIZED FUEL LINES .
- Insert a flat-tip screwdriver [6 mm (0.24 inch) wide and 1 mm (0.04 inch) thick] into the retainer of the fuel main pipe.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.