2012 Mitsubishi RVR ESFACTORY OEM SERVICE PROCEDURE

Generator Assembly: Inspection: Stator

  1. Check the electrical continuity between the stator coil terminals.
  2. Check the electrical continuity of the points shown in the table below. Confirm that there is electrical continuity.
    Fig 1: Identifying Stator
    G07047291Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    If there is not, replace the stator.

    CONTINUITY CHECK

    Terminal connector of tester Electrical continuity
    1 - 2 Presence of electrical continuity
    1 - 3
    2 - 3
    4 - 5
    4 - 6
    5 - 6
  3. Check the insulation between the stator coil terminal and the core.
  4. Check the electrical continuity of the points shown in the table below. Confirm that there is not electrical continuity.
    Fig 2: Checking Stator Continuity
    G07047292Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    If there is, replace the stator.

    CONTINUITY CHECK

    Terminal connector of tester Electrical continuity
    1 - Core Absence of electrical continuity
    2 - Core
    3 - Core
    4 - Core
    5 - Core
    6 - Core
  5. Check the insulation between coil terminals of each group.
  6. Check the electrical continuity of the points shown in the table below. Confirm that there is not electrical continuity.
    Fig 3: Checking Continuity Of Stator
    G07047293Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    If there is, replace the stator.

    CONTINUITY CHECK

    Terminal connector of tester Electrical continuity
    1 - 4 Absence of electrical continuity
    1 - 5
    1 - 6
    2 - 4
    2 - 5
    2 - 6
    3 - 4
    3 - 5
    3 - 6
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.