2012 Mitsubishi Outlander ESFACTORY OEM SERVICE PROCEDURE

Electronic Control AWD DTCS

ELECTRONIC CONTROL AWD DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
C1078 Tire with incorrect diameter equipped
C1456 Wiring harness or coupling coil overcurrent failure
C145A Wiring harness or coupling coil short circuit failure
C145D Wiring harness or coupling open circuit failure
C145F Coupling overload
C1460 Drive mode selector circuit failure
C2100 Abnormal battery voltage (too low)
C2101 Abnormal battery voltage (too high)
C211C Abnormal IG1 power supply low voltage
C211D Abnormal IG1 power supply high voltage
C211E Abnormal power supply voltage (too low)
C211F Abnormal power supply voltage (too high)
C2208 AWD-ECU internal error
U0001 Bus-off error
U0100 Engine CAN time-out
U0121 ABS CAN time-out
U0141 ETACS CAN time-out
U0401 Engine CAN data error
U0415 ABS CAN data error
U113C Wheel speed sensor data error
U1415 Variant coding not implemented
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.