2012 Mitsubishi Outlander ESFACTORY OEM SERVICE PROCEDURE

Generator Assembly: Inspection: Rotor

  1. Measure the resistance between the two slip rings of the rotor coil to check the continuity between them.

    Replace the rotor if the resistance is not within the standard value range.

    Standard value: 2.1 - 2.4 Ω 

  2. Check the continuity between the slip rings and core.
    Fig 1: Measuring Resistance Between Two Slip Rings Of Rotor Coil
    G05375419Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. If continuity is present, replace the rotor.
    Fig 2: Checking Continuity Between Slip Rings And Core
    G05375420Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.