Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mitsubishi Outlander ESFACTORY OEM SERVICE PROCEDURE
Window Glass: Specifications: General: Items
ADHESIVE SPECIFICATIONS
| Item | Application | Quantity |
|---|---|---|
| Wire (diameter x length) | For cutting adhesive | Five pieces of wire 0.6 mm x 1 m (0.02 in x 3.3 ft) |
| Glass adhesive knife | For cutting adhesive | One |
| Sealant gun | For adhesive application | One |
| Wiping shop towels | - | As required |
| Sealer | For prevention of water and wind leaks after adhesive application | As required |
| 3M™ AAD Part No. 8906 or equivalent | For cleaning or degreasing body parts and glasses | As required |
| Glass holder MB990480 | For securing of window glass | Two |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.