2012 Mitsubishi Lancer Evolution GSRFACTORY OEM SERVICE PROCEDURE

Learning Procedure

  1. Start the engine and warm to reach 80°C (176°F) or more.
    NOTE: When the engine coolant temperature is 80°C (176°F) or more, the warm-up is not needed if the ignition switch is in "ON" position once.
  2. Turn the ignition switch to "LOCK" (OFF) position.
  3. After 10 seconds or more, start the engine again.
  4. For 10 minutes, carry out the idling under the condition shown below and then confirm the engine idles normally.
    • Transaxle: Neutral (P range on vehicles with TC-SST)
    • Operation in ignition-related, fan and attachments: Not to be operated
    • Engine coolant temperature: 80°C (176°F) or more
      NOTE: If the engine stalls while idling, check for a dirty (on the throttle valve) of the throttle body and clean if needed. Then perform the service from Procedure 1 again.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.