Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mitsubishi Eclipse SEFACTORY OEM SERVICE PROCEDURE
Service Specifications
SERVICE SPECIFICATION
| Item | Standard value | Limit | ||
|---|---|---|---|---|
| Steering wheel free play mm (in) | With engine running | - | 30 (1.2) | |
| With engine stopped | 10 (0.4) or less | - | ||
| Steering angle | Inner wheel | 31Β°48' Β± 2Β°00' (Left/right deviation within 2Β°00') | - | |
| Outer wheel (reference value) | 27Β°06' | - | ||
| Toe-in mm (in) | 0 Β± 3 (0 Β± 0.12) | - | ||
| Tie rod end ball joint breakaway torque N.m (in-lb) | 0.5 - 3.5 (4.4 - 31.0) | - | ||
| Tie rod swing resistance N (lb) [Tie rod swing torque N.m (in-lb)] | 3.6 - 17.6 (0.81 - 3.96) [1.0 - 4.9 (8.9 - 43.3)] | - | ||
| Stationary steering effort N (lb) [Fluctuation allowance N (lb)] | 35 (7.9) or less [5.9 (1.33) or less] | - | ||
| Oil pump pressure MPa (psi) | Oil pump relief pressure | 8.3 - 8.8 (1, 204 - 1, 276) <2.4L Engine> 9.3 - 9.8 (1, 349 - 1, 421) <3.8L Engine> |
- | |
| Pressure under no-load conditions | 0.8 - 1.0 (116 - 145) | - | ||
| Steering gear retention hydraulic pressure | 8.3 - 8.8 (1, 204 - 1, 276) <2.4L Engine> 9.3 - 9.8 (1, 349 - 1, 421) <3.8L Engine> |
- | ||
| Oil pressure switch operating pressure MPa (psi) | OFF β ON | 1.8 - 2.4 (261 - 348) | - | |
| ON β OFF | 1.0 (145) or less | - | ||
| Steering gear total pinion torque N.m (in-lb) [Change in torque N.m (in-lb)] | 0.8 - 1.9 (7.1 - 16.8) [0.7 (6.2) or less] | - | ||
| Band crimped width mm (in) | 1.4 - 1.8 (0.06 - 0.07) | - | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
