2012 Mitsubishi Eclipse SEFACTORY OEM SERVICE PROCEDURE

General Specifications

GENERAL SPECIFICATION

Item 2.4L Engine 3.8L Engine
Steering wheel Type 4-spoke type
Outside diameter mm (in) 370 (14.6)
Maximum number of turns 2.64
Steering column Column mechanism Shock absorbing mechanism and Tilt steering mechanism
Power steering type Integral type (Engine speed-dependent type)
Oil pump Type Vane type with fluid flow amount control system
Basic discharge amount cm3 /rev. (cu in/rev) 9.6 (0.59)
Relief pressure MPa (psi) 8.8 (1, 277) 9.8 (1, 422)
Reservoir type Separate type (plastic)
Pressure switch Equipped
Steering gear Type Rack and pinion
Stroke ratio (Rack stroke/Steering wheel maximum number of turns) mm/rev (in/rev) 49.62 (1.95)
Rack stroke mm (in) 131 (5.2)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.