2012 Mitsubishi Eclipse SEFACTORY OEM SERVICE PROCEDURE

BARTEC TPMS Reset Procedure

OBD Connect

  1. Inflate tires to placard.
  2. Read all sensor IDs using tool.
  3. Connect tool to OBDII port.
  4. Turn ignition ON.
  5. Write IDs using tool.
  6. Tool will display RELEARN COMPLETE and light should be off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.