2012 Mitsubishi Eclipse SEFACTORY OEM SERVICE PROCEDURE

Rotor Check

  1. Check the continuity between the slip rings of the field coil. If the resistance value is not within the standard value, replace the rotor.

    Standard value: approximately 2 - 5 Ω 

    Fig 1: Checking Continuity Between Slip Rings Of Field Coil
    G06248654Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check the continuity between the slip ring and the core. If there is continuity, replace the rotor.
    Fig 2: Checking Continuity Between Slip Ring And Core
    G06248655Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.