Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mitsubishi Eclipse GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
General Specifications
GENERAL SPECIFICATION
| Item | 2.4L Engine | 3.8L Engine | |
|---|---|---|---|
| Steering wheel | Type | 4-spoke type | |
| Outside diameter mm (in) | 370 (14.6) | ||
| Maximum number of turns | 2.64 | ||
| Steering column | Column mechanism | Shock absorbing mechanism and Tilt steering mechanism | |
| Power steering type | Integral type (Engine speed-dependent type) | ||
| Oil pump | Type | Vane type with fluid flow amount control system | |
| Basic discharge amount cm3 /rev. (cu in/rev) | 9.6 (0.59) | ||
| Relief pressure MPa (psi) | 8.8 (1, 277) | 9.8 (1, 422) | |
| Reservoir type | Separate type (plastic) | ||
| Pressure switch | Equipped | ||
| Steering gear | Type | Rack and pinion | |
| Stroke ratio (Rack stroke/Steering wheel maximum number of turns) mm/rev (in/rev) | 49.62 (1.95) | ||
| Rack stroke mm (in) | 131 (5.2) | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
