2012 Mitsubishi Eclipse GS, Automatic TransFACTORY OEM SERVICE PROCEDURE

Rectifier Check

  1. Check the continuity between the positive rectifier and the stator coil lead connection terminal with a tester. If there is continuity between the terminals, the diode is shorted, so replace the rectifier.
    Fig 1: Checking Continuity Between Positive Rectifier And Stator Coil Lead Connection Terminal With Tester
    G06248659Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check the continuity between the negative rectifier and the stator coil lead connection terminal with a tester. If there is continuity between the terminals, the diode is grounded, so replace the rectifier.
    Fig 2: Checking Continuity Between Negative Rectifier And Stator Coil Lead Connection Terminal With Tester
    G06248658Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.