Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Mitsubishi Eclipse GS, Automatic TransFACTORY OEM SERVICE PROCEDURE
Special Tools
SPECIAL TOOLS SPECIFICATION
| TOOL | TOOL NUMBER AND NAME | SUPERSESSION | APPLICATION |
|---|---|---|---|
MB991958
M.U.T.-III sub assembly
|
MB991824-KIT
NOTE:
G: MB991826 M.U.T.-III trigger harness is not necessary when pushing V.C.I. ENTER key.
|
SWS communication line check (ECU check and service data)
CAUTION:
For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
|
|
| MB991997 ASC check harness |
- | TCL/ASC-ECU terminal voltage measurement | |
MB991223
Harness set
|
General service tool (jumper) | Making voltage and resistance measurements during troubleshooting
|
|
| MB992006 Extra fine probe |
- | Making voltage and resistance measurement during troubleshooting | |
| MB991348 The harness set |
- | For checking of G and yaw rate sensor input voltage measurement |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
