Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Mitsubishi Eclipse GTFACTORY OEM SERVICE PROCEDURE
Key Interlock And Shift Lock Mechanism Check
- Carry out the following inspection.INSPECTION CHART
KEY INTERLOCK SIDE INSPECTION PROCEDURE INSPECTION REQUIREMENT INSPECTION ITEM (NORMAL CONDITION) 1 Brake pedal: Depressed Ignition key position: "LOCK" (OFF) or removed Unable to push in the selector lever push button and move the lever out of the "P" position. 2 Ignition key position: "ACC" Able to push in the selector lever push button, move the lever out of the "P" position, and shift to any position. 3 Brake pedal: Not depressed Selector lever: Other than "P" position Unable to turn the ignition key to the "LOCK" (OFF) position. 4 Selector lever: "P" position Able to turn the ignition key to the "LOCK" (OFF) position. INSPECTION CHARTSHIFT LOCK SIDE INSPECTION PROCEDURE INSPECTION CONTENTS CHECK DETAILS (NORMAL CONDITION) 1 Brake pedal: Not depressed Ignition key position: "ACC" When the selector lever push button is depressed, the selector lever cannot be shifted out of the "P" position. 2 Brake pedal: Depressed When the selector lever push button is depressed, the selector lever can be shifted smoothly to another position. 3 Brake pedal: Not depressed When the selector lever push button is depressed, the selector lever can be shifted smoothly from the "R" position to the "P" position. - When any of the above checks are not normal, adjust the key interlock cable and shift lock cable unit by following procedure.
- Remove the front floor console. (Refer to FLOOR CONSOLE ASSEMBLY ).
- Shift selector lever to "P" position.
- Turn the ignition key to "LOCK" (OFF) position.
- Loosen the bolt fixing the shift lock cable unit, push the lever in direction B and the unit in direction C and tighten the bolt at the standard torque.
Tightening torque: 5.0 Β± 1.0 N.m (44 Β± 9 in-lb)Β
- Lift the lock guide of the key interlock cable to unlock it.
- Lower the lock guide of the key interlock cable and then lock it.NOTE: The key interlock cable is adjusted according to the lock position (cap push state) at this time. Readjust the lock position if the key interlock still does not operate correctly.
- After adjustment, re-check the operations. Replace the key interlock cable and shift lock cable unit if operations are defective. (Refer to A/T KEY INTERLOCK AND SHIFT LOCK MECHANISMSΒ ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
