Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mitsubishi Lancer Evolution GSRFACTORY OEM SERVICE PROCEDURE
Tightening Torque: Notes
Each torque value in the table is a standard value for tightening under the following conditions.
- Bolts, nuts and washers are all made of steel and plated with zinc.
- The threads and bearing surface of bolts and nuts are all in dry condition.
The values in the table are not applicable:
- If toothed washers are inserted.
- If plastic parts are fastened.
- If bolts are tightened to plastic or die-cast inserted nuts.
- If self-tapping screws or self-locking nuts are used.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.