Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Mitsubishi Lancer ES, StandardFACTORY OEM SERVICE PROCEDURE
Keyless Entry System Check
WARNING: This page is about a different variant/trim than selected.
Check the keyless entry system as described below. If it does not work, perform troubleshooting. Refer to TROUBLE SYMPTOM CHART .
- Operate the transmitter to check that the doors can be locked and unlocked.
- Operate the transmitter to check that the answerback function works in response to doors locking/unlocking.NOTE: The hazard answerback setting can be changed using the customization function. Confirm which setting is activated before performing these checks. Refer to CUSTOMIZATION FUNCTION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.