2007 Mitsubishi Lancer StandardFACTORY OEM SERVICE PROCEDURE

BARTEC TPMS Reset Procedure

IMPORTANT: Mitsubishi Adapter must be connected to the 400P/400SD/500. ADAPTER is NOT NEEDED on the PRO SERIES TOOLS.

You will select either

  • Reduce pressure to activate sensors.
  • Use a second activation tool to activate sensor.

OBD Connect: Assisted Relearn

  1. Inflate tires to correct pressure.
  2. Read all sensor IDs using tool.
  3. Connect tool to OBDII port using the Mitsubishi adapter.
  4. Turn Ignition ON.
  5. Follow on screen prompts to relearn IDS to the vehicle.
  6. Tool will indicate relearn completed.
NOTE: If you reduced the pressure to complete, your TPMS light may be on until tires are inflated to placard.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.