Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mitsubishi Lancer AutomaticFACTORY OEM SERVICE PROCEDURE
Auto-Cruise Control (2.0L) DTCS
AUTO-CRUISE CONTROL (2.0L) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | INSPECTION ITEM |
|---|---|
| 11 | Auto-cruise vacuum pump drive system |
| 12 | Vehicle speed signal system < M/T > |
| Vehicle speed signal system < A/T > | |
| 14 | Auto-cruise vacuum pump power supply system |
| 15 | Auto-cruise control switch system |
| 16 | Auto-cruise control-ecu system |
| 17 | Throttle position sensor and, idle position signal system < M/T > |
| Throttle position sensor and, idle position signal system < A/T > |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
