2007 Mitsubishi Lancer AutomaticFACTORY OEM SERVICE PROCEDURE

Valve Body Spring Identification Table

VALVE BODY SPRING IDENTIFICATION

SPRING WIRE DIAMETER mm (in) OUTSIDE DIAMETER mm (in) FREE LENGTH mm (in) NUMBER OF LOOPS
Regulator valve spring 1.8 (0.071) 15.7 (0.618) 86.7 (3.413) 24
Underdrive pressure control valve spring 0.7 (0.028) 7.6 (0.299) 37.7 (1.484) 25
Overdrive pressure control valve spring 0.7 (0.028) 7.6 (0.299) 37.7 (1.484) 25
Low-reverse pressure control valve spring 0.7 (0.028) 7.6 (0.299) 37.7 (1.484) 25
Second pressure control valve spring 0.7 (0.028) 7.6 (0.299) 37.7 (1.484) 25
Torque converter spring 1.6 (0.063) 11.2 (0.441) 34.4 (1.354) 12.5
Torque converter clutch control valve spring 0.7 (0.028) 5.9 (0.232) 28.1 (1.106) 19
Fail-safe valve spring 0.7 (0.028) 8.9 (0.350) 21.9 (0.862) 9.5
Damping valve spring 1.0 (0.039) 7.7 (0.303) 35.8 (1.409) 17
Line relief valve spring 1.0 (0.039) 7.0 (0.276) 17.3 (0.681) 10
Orifice check ball spring 0.5 (0.020) 4.5 (0.177) 17.2 (0.677) 15
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.