Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Mitsubishi Lancer AutomaticFACTORY OEM SERVICE PROCEDURE
General Specifications
GENERAL SPECIFICATIONS
| ITEM | SPECIFICATION | ||
|---|---|---|---|
| Model | F4A4B-1-J1Z | F4A4B-4-L2Z | |
| Type | Electronically controlled 4-speed full-automatic | ||
| Torque converter | Type | 3-element with torque converter clutch | |
| Stall torque ratio | 2.1 | 2.0 | |
| Gear ratio | 1st | 2.842 | |
| 2nd | 1.529 | 1.573 | |
| 3rd | 1.000 | ||
| 4th | 0.712 | 0.688 | |
| Reverse | 2.480 | 2.214 | |
| Final gear ratio | 4.041 | 4.212 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
