Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2007ENDEAVOR SE, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPBODYDOORINSPECTIONPOWER WINDOW MAIN SWITCH'S FRONT < LH > SWITCH CHECK
2007 Mitsubishi Endeavor SE, FWD
Power Window Main Switch's Front < LH > Switch Check
2007 Mitsubishi Endeavor SE, FWDSECTION Power Window Main Switch's Front < LH > Switch Check
Connect the terminal number 13 to the battery (+) post, and the terminal number 12 to the battery (-) post.
MAIN SWITCH
TESTING POWER WINDOW MAIN SWITCH
| SWITCH POSITION | TESTER CONNECTION | SPECIFIED CONDITION | |||
|---|---|---|---|---|---|
| FRONT (LH) | UP | 8 - 13, 9 - 12, | Less than 2 ohms | ||
| OFF | 8 - 12, 9 - 12 | Less than 2 ohms | |||
| DOWN | 9 - 13, 8 - 12 | Less than 2 ohms | |||
| FRONT (RH) | UP | 3 - 13, 11 - 12(1) | Less than 2 ohms | ||
| OFF | 3 - 11, 3 - 12(1), 11 - 12(1) | Less than 2 ohms | |||
| DOWN | 11 - 13, 3 - 12(1) | Less than 2 ohms | |||
| REAR (LH) | UP | 1 - 13, 2 - 12(1) | Less than 2 ohms | ||
| OFF | 1 - 2, 1 - 12(1), 2 - 12(1) | Less than 2 ohms | |||
| DOWN | 2 - 13, 1 - 12(1) | Less than 2 ohms | |||
| REAR (RH) | UP | 13 - 14, 6 - 12(1) | Less than 2 ohms | ||
| OFF | 6 - 14, 6 - 12(1), 12(1) -- 14 | Less than 2 ohms | |||
| DOWN | 6 - 13, 12(1) -- 14 | Less than 2 ohms | |||
|
|||||
SUB SWITCH < FRONT >
TESTING POWER WINDOW FRONT SUB SWITCH
| SWITCH POSITION | TESTER CONNECTION | SPECIFIED CONDITION |
|---|---|---|
| UP | 4 - 5, 6 - 7 | Less than 2 ohms |
| OFF | 4 - 5, 6 - 8 | Less than 2 ohms |
| DOWN | 4 - 7, 6 - 8 | Less than 2 ohms |
SUB SWITCH < REAR >
TESTING POWER WINDOW REAR SUB SWITCH
| SWITCH POSITION | TESTER CONNECTION | SPECIFIED CONDITION |
|---|---|---|
| UP | 4 - 5, 6 - 7 | Less than 2 ohms |
| OFF | 4 - 5, 7 - 8 | Less than 2 ohms |
| DOWN | 4 - 6, 7 - 8 | Less than 2 ohms |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.