2006 Mitsubishi MonteroFACTORY OEM SERVICE PROCEDURE

Warning/Caution Labels

A number of caution labels related to the SRS are found in the vehicle, as shown in the following illustration. Follow label instructions when servicing SRS. The label K is not to be removed except by owner. If the other labels are dirty or damaged, replace them.

Fig 1: Identifying Warning/Caution Labels Location
G04267878Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
LABEL CONTENTS REFERENCE

LABEL CONTENTS
A
CAUTION: SRS BEFORE REPLACING STEERING WHEEL, READ SERVICE INFORMATION. THIS AIR BAG MODULE CANNOT BE REPAIRED. DO NOT DISASSEMBLE OR TAMPER.
B
WARNING: FLAMMABLE MATERIAL TO PREVENT PERSONAL INJURY. DO NOT DISMANTLE. INCINERATE OR BRING INTO CONTACT WITH ELECTRICITY, STORE BELOW 200°F (93°C). READ SERVICE INFORMATION FOR DETAIL.
C
CAUTION: SRS CLOCKSPRING
THIS IS NOT A REPAIRABLE PART. IF DEFECTIVE REPLACE ENTIRE UNIT ACCORDING TO THE SERVICE INFORMATION INSTRUCTIONS. TO RE-CENTER: ROTATE CLOCKWISE UNTIL TIGHT. THEN ROTATE IN OPPOSITE DIRECTION ROUGHLY 3 3/4 TURNS AND ALIGN ARROWS ><.
D, H
WARNING: FLAMMABLE/EXPLOSIVE
SRS AIR BAG MODULE
TO AVOID SERIOUS INJURY:
  • DO NOT REPAIR, DISASSEMBLE OR TAMPER.
  • AVOID CONTACT WITH FLAME OR ELECTRICITY.
  • DO NOT DIAGNOSIS/USE NO TEST EQUIPMENT OR PROBES.
  • STORE BELOW 200°F (93°C).
  • BEFORE DOING ANY WORK INVOLVING MODULE, READ SERVICE INFORMATION FOR IMPORTANT FURTHER DATA.
E, L
CAUTION: DO NOT DISASSEMBLE OR DROP. IF DEFECT REFER TO SERVICE INFORMATION .
F
G04267879
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.