2006 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

Visual Inspection

  • Connector is disconnected or improperly connected
  • Connector pins are pulled out
  • Stretched an broken wires at terminal section
  • Low contact pressure between male and female terminals
  • Low connection pressure due to rusted terminals or foreign matter lodged in terminals
    Fig 1: Identifying Low Contact Pressure Between Male And Female Terminals
    G04293842Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.