Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Engine control system | |
| Accelerator cable attaching bolt | 5.0 +/- 1.0 N. m (44 +/- 9 in-lb) |
| Accelerator cable clamp attaching bolt | 11 +/- 1 N. m (97 +/- 9 in-lb) |
| Accelerator cable clamp attaching bolt | 5.0 +/- 1.0 N. m (44 +/- 9 in-lb) |
| Accelerator pedal bracket installation nut | 12 +/- 2 N. m (102 +/- 22 in-lb) |
| Emission control system | |
| EGR valve bolt | 20 +/- 2 N. m (15 +/- 1 ft-lb) |
| Charge air cooler air hose E clamp bolt | 6.0 +/- 1.0 N. m (53 +/- 9 in-lb) |
| Catalytic converter nut | 59 +/- 10 N. m (44 +/- 7 ft-lb) |
| Front exhaust pipe bolt (catalytic converter side) | 49 +/- 10 N. m (37 +/- 7 ft-lb) |
| Front exhaust pipe bolt (exhaust fitting side) | 50 +/- 5 N. m (37 +/- 4 ft-lb) |
| Hanger bolt | 13 +/- 2 N. m (111 +/- 22 in-lb) |
| Heated oxygen sensor (rear) | 44 +/- 5 N. m (33 +/- 3 ft-lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.