Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Fuel Pump Resistor (B-121) | Right rear of engine compartment. See Figure . |
| Fusible Link No. 26 | On positive battery terminal. See Figure . |
| Fusible Links No. 1, 2, 3, 4 & 5 | In engine compartment relay box. See Figure . |
| Injector Resistor (B-119) | At right rear of engine compartment. See Figure . |
| Junction Block | Behind left end of dash. See Figure . |
| Relay Box | On left side of engine compartment. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.