Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Individual Component Service
- If heat damage occurs during paint work, remove the SRS-ECU, the air bag modules, the clock spring, front seats, and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them.
- SRS-ECU, air bag module, clock spring: 93° C (200° F) or more
- Seat belt with pre-tensioner: 90°C (194° F) or more
- If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this section. (Front impact sensor: refer to FRONT IMPACT SENSORS , SRS-ECU: refer to SRS CONTROL UNIT (SRS-ECU) , Air bag modules and clock spring: refer to AIR BAG MODULE(S) AND CLOCK SPRING , Side impact sensor: refer to SIDE IMPACT SENSOR , Seat belt with pre-tensioner: refer to SEAT BELTS WITH PRE-TENSIONER ).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
