Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mitsubishi MonteroFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| ITEM | SPECIFICATION |
|---|---|
| Emission control system | |
| Bracket bolt | 49 ± 10 N.m (37 ± 7 ft-lb) |
| Front exhaust pipe bolt | 25 ± 4 N.m (18 ± 3 ft-lb) |
| Heated oxygen sensor | 44 ± 5 N.m (33 ± 3 ft-lb) |
| Main muffler nut | 49 ± 10 N.m (37 ± 7 ft-lb) |
| Warm up three way catalytic converter bolt | 49 ± 4 N.m (37 ± 3 ft-lb) |
| Warm up three way catalytic converter nut | 49 ± 10 N.m (37 ± 7 ft-lb) |
| Engine control system | |
| Accelerator pedal bracket nut | 12 ± 2 N.m (102 ± 22 in-lb) |
| Accelerator pedal position sensor bolt | 3.5 ± 1.0 N.m (31 ± 9 in-lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.