Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Manual Transaxle - Evolution DTCS
MANUAL TRANSAXLE - LANCER EVOLUTION DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| DTC 12 | Power Supply Voltage (Valve Power Supply) System |
| DTC 13 | Fail-safe Relay System (Inside AWD-ECU) |
| DTC 21, 22, 23, 24 | ABS Sensor (FR/FL/RR/RL) System (Vehicles without ABS) |
| DTC 21, 22, 23, 24 | ABS Sensor (FR/FL/RR/RL) System (Vehicles with ABS) |
| DTC 25 | Wrong-diameter Tire (Vehicles without ABS) |
| DTC 25 | Wrong-diameter Tire (Vehicles with ABS) |
| DTC 26 | ABS Sensor System (Faulty Output Signal) (Vehicles without ABS) |
| DTC 26 | ABS Sensor System (Faulty Output Signal) (Vehicles with ABS) |
| DTC 31 | Steering Angular Velocity Sensor (ST-1, ST-2, ST-N) System |
| DTC 32, 33 | Steering Angular Velocity Sensor (ST-N) System |
| DTC 34 | Steering Angular Velocity Sensor (ST-1, ST-2) System |
| DTC 41, 42 | Throttle Position Sensor System |
| DTC 45 | Pressure Sensor System (Open Circuit or Short Circuit) |
| DTC 46 | Pressure Sensor System (Open Ground) |
| DTC 47 | Pressure Sensor System (Abnormal Power Supply) |
| DTC 51 | G-sensor (Longitudinal) System (Open Circuit or Short Circuit) |
| DTC 52 | G-sensor (Longitudinal) System (Defective Sensor) |
| DTC 56 | G-sensor (Lateral) System (Open Circuit or Short Circuit) |
| DTC 57 | G-sensor (Lateral) System (Defective Sensor) |
| DTC 61 | Stoplight Switch System |
| DTC 62 | ACD Mode Changeover Switch System |
| DTC 63 | Parking Brake Switch System |
| DTC 65 | ABS Monitor System (Vehicles with ABS) |
| DTC 74 | Proportioning Valve System |
| DTC 81 | Electric Pump Relay System (Open Circuit or Short Circuit) |
| DTC 82 | Electric Pump Relay System |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
