Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Body -- Evolution
- Body Diagnosis
- On-Vehicle Service
- Hood
- Fender
- Fuel Filler Lid
- Strut Tower Bar
- Rear End CROSSMEMBER Bar < RS >
- Window Glass
- Door
- Door
- Door Diagnosis
- Introduction To Glass And Door Diagnosis
- Glass And Door Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Water Leak Through Door Window Glass
- INSPECTION PROCEDURE 2: Door Window Glass Malfunction
- INSPECTION PROCEDURE 3: Water Leak Through Door Edge
- INSPECTION PROCEDURE 4: Water Leak from Door Center
- INSPECTION PROCEDURE 5: Door Hard to Open
- INSPECTION PROCEDURE 6: Door does not Open or Close Completely
- INSPECTION PROCEDURE 7: Uneven Gap Between Body
- INSPECTION PROCEDURE 8: Wind Noise Around Door
- How To Locate Wind Noise
- Special Tools
- On-Vehicle Service
- Door Fit Adjustment
- Door Window Glass Adjustment
- Glass Sliding Mechanism Check And Adjustment
- Power Window Timer Function Check
- Power Window Operating Current Check
- Power Window Relay Check
- Circuit Breaker (Incorporated In The Power Window Motor) Inspection
- Power Window Check
- Central Door Locking System Inspection
- Door Outside Handle Play Check
- Door Inside Handle Play Adjustment
- Door Assembly
- Door Glass And Regulator
- Door Handle And Latch
- Window Glass RUNCHANNEL And Door Opening Weatherstrip
- Trunk Lid
- Keyless Entry System
- General Description
- Keyless Entry System Diagnosis
- Special Tools
- On-Vehicle Service
- How To Replace The Transmitter Battery
- Keyless Entry System Timer Lock Function Inspection
- Enabling/Disabling The ANSWERBACK Function
- Enabling/Disabling The Hazard ANSWERBACK Function
- Notes
- < When The Transmitter Is Used After Grounding Data Link Connector Terminal 1 >
- < When The Transmitter Is Used After Connecting The Special Tool MB991824 (V.C.I.) To The Data Link Connector >
- < How To Adjust Hazard ANSWERBACK When The Transmitter Is Used To Lock Doors >
- < How To Adjust Hazard ANSWERBACK When The Transmitter Is Used To Unlock Doors >
- Enabling/Disabling The Horn ANSWERBACK Function
- How To Register Secret Code
- Sunroof Assembly < GSR >
- Specifications
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.