Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mitsubishi Galant ESFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
FASTENER TIGHTENING SPECIFICATIONS
| ITEM | SPECIFICATION |
|---|---|
| Auto-cruise control system | |
| Lower cover cap bolt | 9.0 +/- 2.0 N.m (80 +/- 17 in-lb) |
| Steering wheel assembly nut | 41 +/- 8 N.m (30 +/- 6 ft-lb) |
| Emission control system | |
| EGR valve bolt | 24 +/- 3 N.m (18 +/- 2 ft-lb) |
| Grounding bolt < 2.4L ENGINE > | 5.0 +/- 1.0 N.m (44 +/- 9 in-lb) |
| Engine control system | |
| Accelerator pedal assembly nut | 13 +/- 2 N.m (111 +/- 22 in-lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.