Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Mitsubishi Eclipse GTS, StandardFACTORY OEM SERVICE PROCEDURE
Traction Control System
- General Description
- Traction Control System (TCL) Diagnosis
- TCL Diagnostic Trouble Code Detection Conditions
- TCL Diagnostic Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC 31, 32, 33, 34: TCL Solenoid Valve inside Hydraulic Unit (Open Circuit or Short Circuit) /DTC 41, 42,43, 44,45,46, 47,48: ABS Solenoid Valve inside Hydraulic Unit (Open Circuit or Short Circuit) /DTC 51: Valve Power Supply /DTC 53: Pump Motor
- Circuit Operation
- TCL DTC Set Conditions
- TROUBLESHOOTING HINTS (The most likely causes for these DTCs are to set are:)
- Diagnosis
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication between the Scan Tool and the ABS-ECU is not Possible.
- INSPECTION PROCEDURE 2: When the Ignition Key is Turned to the "ON" Position (Engine Stopped), the TCL Indicator Light does not Illuminate.
- INSPECTION PROCEDURE 3: When the Ignition Key is Turned to the "ON" Position (Engine Stopped), the TCL Warning Light does not Illuminate.
- INSPECTION PROCEDURE 4: The TCL Indicator Light Remains Illuminated after the Engine is Started.
- INSPECTION PROCEDURE 5: The TCL Warning Light Remains Illuminated after the Engine is Started.
- INSPECTION PROCEDURE 6: The TCL System does not Operate.
- Data List Reference Table
- Actuator Test Reference Table
- Check At Abs-Ecu
- Resistance And Continuity Between Harness-Side Connector Terminals
- Special Tools
- On-Vehicle Service
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
