Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Outlander LS, FWDFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| ITEMS | SPECIFICATION |
|---|---|
| Engine control system | |
| Accelerator pedal bracket installation nut | 12 ± 2 N.m (102 ± 22 in-lb) |
| Accelerator pedal position sensor assembly attaching bolt | 12 ± 1 N.m (102 ± 13 in-lb) |
| Accelerator pedal position sensor bracket attaching bolt | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Accelerator pedal position sensor bracket support attaching bolt | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Auto-cruise control system | |
| Powertrain control module(ECU) | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Emission control system | |
| Catalytic converter bolt | 49 ± 10 N.m (37 ± 7 ft-lb) |
| Catalytic converter nut | 59 ± 10 N.m (44 ± 7 ft-lb) |
| EGR valve bolt | 12 ± 1 N.m (102 ± 13 in-lb) |
| Heated oxygen sensor (Front) | 44 ± 5 N.m (33 ± 3 ft-lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.